Connecting A Terminal - Avaya 8800 Commissioning Manual

install
reset-passwd
show bootconfig master

Connecting a terminal

Connect a terminal to the serial console interface to monitor and configure the switch.
Prerequisites
• To use the console port, you need the following equipment:
- A terminal or teletypewriter (TTY)-compatible terminal, or a portable computer with
a serial port and terminal-emulation software.
- An Underwriters Laboratories (UL)-listed straight-through or null modem RS-232
cable with a female DB-9 connector for the console port on the switch. The other
end of the cable must use a connector appropriate to the serial port on your computer
or terminal. Most computers or terminals use a male DB-25 connector. A null modem
cable is shipped with the chassis.
• You must shield the cable connected to the console port to comply with emissions
regulations and requirements.
Commissioning
Command Parameter
portlock <on|off>
sendAuthenticationTrap <true|false>
topology <on|off>
udp-checksum <enable|disable>
udpsrc-by-vip <enable|disable>
vlan-bysrcmac <enable|disable>
name <prompt>
name <prompt>
delay
loadconfigtime
logfile
master
Connecting a terminal
June 2011 29