Outputs Panel
The Outputs panel (see figure 54,
rate of the outputs, their signal type (HDMI or DVI), and the HDCP status of all connected
outputs.
The following status symbols may be displayed for connected outputs:
Symbol
No Display
Roles and Permissions Panel
In this panel (
NOTE: The following rules apply to passwords:
•
Length is 1-128 characters.
•
All human-readable characters are permitted except | .
•
The password cannot be a single space unless you are removing the password
entirely.
•
Passwords are case-sensitive.
•
A user password cannot be assigned if no administrator password exists.
•
If the Admin password is cleared, the user password is cleared as well.
Setting a password
NOTE: The initial factory configured passwords for all accounts on this device have
been set to the device serial number. Passwords are case sensitive. In the event of an
absolute system reset, the passwords are reset to no password.
The web password is administrator level. Passwords are case sensitive.
To assign new administrator and user passwords:
In the Roles and Permissions panel, click
1.
Settings dialog box opens
2.
In the Admin panel, click the Change Admin Password link and enter the new
administrator password in the field below (see figure 60,
3.
Click in the Confirm Admin Password field (
Change
, on page 93) displays the resolution and refresh
5
Definition
The display is HDCP compliant.
The display is not HDCP compliant.
No display is connected.
) you can set and remove administrator and user passwords.
6
field.
Admin Password
. The Role and Permission
Edit
, on the next page).
1
) and repeat the password from the
2
DXP HD 4K PLUS Series • Internal Web Page
98