Extron electronics DXP HD 4K PLUS Series User Manual page 37

Selecting front panel lock mode 2 or toggling between lock modes 2
and 1
NOTES:
• If the switcher is in lock mode 1, this procedure selects mode 2.
•
If the switcher is in lock mode 2, this selects mode 1 (locks all switcher functions
except selecting mode 2).
Toggle the lock on and off by pressing and holding the Esc and I/O buttons until the
following LEDs blink twice (approximately 3 seconds).
• The Esc, Video, and Audio LEDs blink twice if the DXP is now in lock mode 2.
The Video and Audio LEDs blink twice if the DXP is now in lock mode 1.
•
NOTE: To switch from lock mode 1 (front panel is completely locked) to lock mode 0
(front panel is unlocked), you must first switch to mode 2, then from mode 2 to
mode 0 (see figure 28).
Press and hold
simultaneously.
ESC I/O
3 seconds
VIDEO
ESC I/O
AUDIO
The Esc, Video, and Audio LEDs
blink twice.
Release the buttons.
Figure 28. Toggling between Lock Modes 1 and 2
Switching from Lock Mode 1 to Lock Mode 0
If the switcher is in lock mode 1, you cannot change it directly to lock mode 0 (completely
unlocked). You must first place the switcher in lock mode 2, then toggle it to mode 0 (see
Selecting Front Panel Lock Mode 2 or Toggling between Lock Modes 2 and 0
page 28).
DXP HD 4K PLUS Series • Operation
on
29