Device-Initiated Messages - Extron electronics DXP HD 4K PLUS Series User Manual

Device-Initiated Messages

When a local event such as a front panel selection or adjustment takes place, the matrix
switcher responds by sending a message to the host. No response is required from the
host. Example switcher-initiated messages are listed here.
] Password:
•
]
The
followed by a carriage return. If the correct password is entered, the unit responds with
]
Login Administrator
entered. If passwords are the same for both administrator and user, the switcher
defaults to administrator privileges.
The password prompt is redisplayed if an incorrect password is entered.
NOTES:
•
•
]
• Qik
The switcher initiates the Qik message when a front panel switching operation occurs.
X1&]
Rpr
•
The switcher initiates the Rpr message when a memory preset is recalled from the front
panel.
X1&]
Spr
•
The switcher initiates the Spr message when a memory preset is saved from the front
panel.
X@
Vmt
•
The switcher initiates the Vmt message when a video output mute is toggled on or off
from the front panel.
1 = on).
X@
Amt
•
The switcher initiates the Amt message when an audio output mute is toggled on or off
from the front panel.
X2)]
Exe
•
The switcher initiates the Exe message when the Front Panel Lockout mode is toggled
on or off from the front panel.
mode only)
HplgO
•
The switcher initiates the HplgO message when a hot plug event is detected on an
output (for example, if the display is disconnected from the unit).
number.
Reconfig
•
The switcher sends this response upon any change of input frequency on the currently
selected input or inputs.
Password: prompt requires a password (administrator level or user level)
]
or
The factory configured passwords for all accounts on these devices have been
set to the device serial number. Passwords are case sensitive.
Performing a unit factory reset (entering an
a mode 5 reset via the rear panel Reset button) removes the serial number
passwords, leaving the unit with no password.
X1&
is the preset number.
X1&
is the preset number.
X1@]
*
X@
is the output number.
X1#]
*
X@
is the output number.
X2)
X@ ]
]
DXP HD 4K PLUS Series • SIS Configuration and Control
] ]
Login User , depending on the password
E
ZQQQ }
X1@
is the video mute status (0 = off,
X1#
is the mute status (0 = off, 1 = on).
is the lock mode (0 = off, 1 = view only, 2 = basic
SIS command or
X@
is the output
40