Extron electronics DXP HD 4K PLUS Series User Manual page 19

Crossover Cable
Pins:
1 2 3 4 5 6 7 8
End 1
Pin Wire Color
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
6 Orange
7 White-brown
Insert Twisted
8 Brown
Pair Wires
T568A
RJ-45
Connector
A cable that is wired as T568A at one end
and T568B at the other (Tx and Rx pairs
reversed) is a "crossover" cable.
Figure 6. RJ-45 Connector and Pinout Tables
The cable used depends on your network speed. The switcher supports both
10 Mbps (10Base-T — Ethernet) and 100 Mbps (100Base-T — Fast Ethernet), half-duplex
and full-duplex, Ethernet connections.
• 10Base-T Ethernet requires CAT 3 UTP or STP cable at minimum.
• 100Base-T Fast Ethernet requires CAT 5e UTP or STP cable at minimum.
The Ethernet cable must be properly terminated for your application as either a crossover or
a straight-through cable.
Crossover cable — Direct connection between the computer and the DXP switcher
•
• Patch (straight-through) cable — Connection of the DXP to a network via a network
switch
Straight-through Cable
End 2
Wire Color Pin
White-orange 1
Orange 2
White-green 3
Blue 4
White-blue 5
Green 6
White-brown 7
Brown 8
T568B
A cable that is wired the same at both ends
is called a "straight-through" cable because
no pin or pair assignments are swapped.
Both ends of the cable can be T568B (as shown)
or T568A (not shown).
DXP HD 4K PLUS Series • Installation
End 1 End 2
Wire Color Wire Color
White-orange White-orange
Orange Orange
White-green White-green
Blue Blue
White-blue White-blue
Green Green
White-brown White-brown
Brown Brown
T568B
T568B
11