Creating The Drive Project Online; Prerequisites - Siemens SINAMICS S120 Getting Started

Creating the Drive Project ONLINE

This chapter shows you how to create the sample project ONLINE by carrying out
the following steps:
S Create a project.
S Enter and configure the component topology and configuration of the drive unit
automatically.
S Configure the drive motors and check the topology.
5.1

Prerequisites

The following prerequisites must be fulfilled before you create a drive project ON-
LINE with the STARTER commissioning tool:
S The components are assembled (as described in Chapter 2).
S The device unit has been switched on in accordance with the instructions.
S The PROFIBUS control unit interface is connected to a PC/PG with PROFIBUS
interface.
The SINAMICS firmware is able to recognize the actual topology automatically and
store it in the appropriate parameters.
 Siemens AG, 2004. All rights reserved
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 04.2004 Edition
5
5-59