Creating the Drive Project ONLINE
6. Choose the appropriate motor from the Motor selection field according
to type (order no.) (see type plate) and assign a name (Drive_1_Motor).
7. Choose Continue > and work through the Wizard until the summary is dis-
played (see Fig. 5-16).
Note
You only have to change the motor configuration; leave the infeed etc. as they are.
Fig. 5-16
8. Choose Finish.
Before saving the project, check the topology in STARTER.
Fig. 5-17
9. Choose Check topology.
5-70
Summary
Device configuration
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 04.2004 Edition
Choose Check topology.
Siemens AG, 2004. All rights reserved