Siemens SINAMICS S120 Getting Started page 27

2.4.2 Using the STARTER control panel (motor rotates)
You have to carry out the following steps to use the STARTER control panel and
activate the motor:
Table 2-2
Step
1
2
3
4
5
2.4.3 Creating the drive project ONLINE
To create the drive project ONLINE, carry out the following steps:
Table 2-3
Step
1
2
3
4
5
6
7
8
 Siemens AG, 2004. All rights reserved
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 04.2004 Edition
Motor rotates
Open the project.
Establish a connection to the target system.
Switch to ONLINE mode.
Load the project to the drive unit. When doing so, watch
the LEDs on the control unit. These indicate when the
project has been fully loaded.
Save the parameters in the drive unit with RAM to ROM.
Use the control panel in the STARTER. The motor starts
to rotate.
ONLINE
Start the STARTER commissioning tool.
Create a new project.
Set up the PROFIBUS interface.
Carry out an ONLINE search for the stations (drive units)
that you can access. The drive unit is inserted in the
project.
Configure and enter the drive unit topology and
configuration automatically.
Configure the motor and check the topology that has been
entered.
Save the project.
Continue with "Using the STARTER control panel (motor
rotates)".
Procedure
Procedure
Prerequisites
Chapter/
section
4.2
4.2
4.2
4.2
4.3
Chapter/
section
5.2
5.2
5.2
5.2
5.3
5.4
5.4
4
J
2-27