Siemens SINAMICS S120 Getting Started page 42

Starter commissioning tool

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Creating the Drive Project OFFLINE

Fig. 3-16

6. You now want to create a drive with a motor module (power section), motor,

and encoder for this example. Confirm the default setting Yes by choosing Con-

tinue >.

Fig. 3-17

7. The drive properties dialog box (see Fig. 3-17) contains general information

about the drive.

8. In the selection field, choose "Operating type".

– Servo: when you are configuring a synchronous motor with servo control

– Vector: when you are configuring an induction motor with vector control

9. Assign a name for the first drive, Drive_1, and enter some general comments.

Choose Continue >.

3-42

SINAMICS_CU320 configuration – Introduction to the drive

Drive properties

SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 04.2004 Edition

Choose Servo or

Vector.

Table of Contents