Siemens SINAMICS S120 Getting Started page 43

Starter commissioning tool

Hide thumbs Also See for SINAMICS S120:

Table of Contents

The following dialog box (see Fig. 3-18) is displayed when you configure an in-

duction motor with vector control.

Configure an induction motor with servo control and then continue with step 11.

Fig. 3-18

10.Choose the "Standard" and "Power unit application" as shown in Fig. 3-18 (the

default setting is "Standard" and can be left as it is). Choose Continue >.

Fig. 3-19

11. Choose the appropriate motor module from the Motor module selection field

according to type (order no.) (see type plate) and assign a name (Power_unit).

SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 04.2004 Edition

Drive settings

Motor module configuration

Creating the Drive Project OFFLINE

3-43

Table of Contents