Creating the Drive Project OFFLINE
Configure an induction motor with servo control and then continue with step 20.
Fig. 3-23
19.Choose Continue > (the default setting for the most important parameters is
"Standard" and can be left as it is).
Fig. 3-24
20.An optional board is not used in this example.
Confirm the default setting No with Continue > so that you can check the data
in the summary (see Fig. 3-25).
3-46
Important parameters
Optional board
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 04.2004 Edition
Siemens AG, 2004. All rights reserved