Configuration Tool - 3Com CommWorks 5210 User Manual

94 A : E M
PPENDIX RROR ESSAGES
There are no commands for this type of device.
Invalid group name: <name>
Invalid command: <name>
Slot <number> T1/PRI query: <specific error>
Invalid time slot range for card: <specification>
Command Specific Parameter exceeds maximum length of <length>
Slot <number>: graphical selection of time slots in this card is not supported.
<target>: Non-command operation
Cancel Execution and exit program?
Program exit during execution

Configuration Tool

This device is not the same type as target(s).
The device configuration files do not list any commands for the target device.
The device configuration files do not list <name> as a valid group.
The device configuration files do not list <name> as a valid command within
the current group.
An error occurred in trying to verify or solicit a time slot range specified against
a T1 or ISDN card.
The user specified a time slot range which includes time slot numbers not valid
for the given type of card.
The user entered a command parameter that was too long (GUI only). The
command will not be executed.
IP Telephony Manager is not able to present a selection dialog for the given
card. (The card type is not supported by this particular version of IP Telephony
Manager.)
Reported in the command tool final summary when a modem test or other
non-command result is in the target's result table. (Non-GUI, warning only.)
Issued in a "Yes/No" dialog when user quits from window frame while
command/test is in progress. (GUI, warning only)
The command or test program was terminated (e.g., by a signal) while a
command or test was in progress. (Non-GUI, warning only)
The following are the Configuration Tool error messages and what they
indicate.
The "load from" source does not match the target devices whose new values
are to be loaded.