Snmp Commands; Setting Snmp Community Strings; Monitoring Snmp Parameters - 3Com CommWorks 5210 User Manual

SNMP Commands 111

SNMP Commands
This describes how to set SNMP community strings and how to monitor the
SNMP parameters.
For security reasons, you can not view the community strings through IP
Telephony Manager.
Setting SNMP This section describes how to set the SNMP community strings.
Community Strings
[x]tcmcs [-h] [-c] readCommunity [-C] writeCommunity
[-z] target
Where:
-c readcomm
SNMP read community string.
-C writecomm
SNMP write community string.
-h
Displays this help message.
-l logfile
Log file for system diagnostic messages. GUI default: log to UNIX syslog; CLI
default: stderr. Specify '-' (hyphen) to reverse these two behaviors.
-z
Disable set logging for this application.
target
IP-address or hostname (in hosts database e.g. /etc/hosts) of the chassis to be
configured.
Monitoring SNMP This section describes how to monitor any SNMP parameter and export the
Parameters results in comma separated version (CSV) format.
tcmperf [-l logfile] [-h] [-c readcomm] [-C writecomm]
[-z] [-L] [-f filename] [-D delimiter]
[-p poll interval] [-s # of samples]
[-G group [parameter]...]... target