Switches (Lcd-E3) - Honeywell Gamewell-FCI E3 Series Installation & Operation Manual

Programming/Operation Instructions

4.3 Switches (LCD-E3)

Figure 4.3.1 illustrates the LCD-E3 switches. Table 4.3.1 lists the LCD-E3 switches and a
description.
Designation
Alarm Acknowledge
Trouble Acknowledge
Signal Silence
Lamp Test/Reset
Menu/Back
BKSP/Edit
OK
Numeric Keys
174
AC POWER POWER GROUND
ON FAULT FAULT
ALARM TROUBLE
ACKNOWLEDGE ACKNOWLEDGE SILENCE
MENU BACKSPACE/
EDIT
Figure 4.3.1 LCD-E3 Switches
Silences the panel audible sounder. This must be pressed once for each
Alarm condition present in the system.
Silences the panel audible sounder. This must be pressed once for each
Trouble or Supervisory condition present in the system.
Press once and any outputs programmed as silenceable will be
deactivated. (All applicable silence LEDs will light). A second activation
will re-activate the previously silenced outputs. This switch only
functions if an Alarm or Supervisory condition exists in the system.
Press momentarily and all LEDs (including all elements in the display)
will light momentarily. Press and hold to reset the system.
Used to access certain system functions, e.g. Walk Test. The display will
prompt the operator as to which function applies.
"Back" function will step the operator out of the menu mode one element
at a time.
Used in menu operations. The display will prompt the operator as to
which function applies.
Accepts any changes made in the Menu field.
These 12 keys allow the user to choose a specific point address by
using the numbers for point sensitivity reading, disabling an address,
etc.
Table 4.3.1 Switches
E3 Series Installation/Operation Manual — P/N 9000-0574:I 11/04/10
ALARM SYSTEM SUPERVISORY SYSTEM
TROUBLE
-QZ ABC
1
2
JKL
GHI
5
4
SIGNAL SYSTEM RESET/
LAMP TEST
PRS TUV
7
.
_
<
0
OK/
ENTER
Comments
Switches (LCD-E3)
SILENCED
DEF
3
MNO
6
WXY
8
9
,
>
into Menu Mode. The