Anx-Sr Wiring Connections - Honeywell Gamewell-FCI E3 Series Installation & Operation Manual

E3 Series System Connections

3.7.6.1 ANX-SR Wiring Connections

Table 3.7.6.1.1 lists the field wiring connections for the ANX-SR sub-assembly.
Designation Description
TB1-1 +24V
TB1-2 GND
TB1-3 +24V
TB1-4 GND
TB2-1 COM A IN
TB2-2 COM B IN
TB2-3 COM A OUT
TB2-4 COM B OUT
TB3-1 RS-232 GND
TB3-2 RS-232 TxD
TB3-3 RS-232 SUPV
TB3-4 RS-232 RxD
W1, W2, W3 Factory Jumpers
W4 ARCNET Termination
SW1-1 Serial Communication
SW1-2 thru ARCNET Address
SW1-8
J1 ETHERNET
J2 Local ARCNET
J4 ARCNET Repeater
Connector
J5 Local ARCNET
LED1 REC
LED2 MRC
LED3 DUP
LED4 TX
LED5 RX
LED6 RST
LED7 DG
118
+24 VDC Input from the PM-9/PM-9G TB4-1
Common negative from the PM-9/PM-9G TB4-2
Local Differential ARCNET
Local Differential ARCNET
Local Differential ARCNET
Local Differential ARCNET
To red lead on download cable P/N 75267
To black lead on download cable P/N 75267
Optional Printer Supervision
To green lead on download cable P/N 75267
Factory Use Only or Right (Default OUT)
OPEN = Normal Operation
SHORT = If the ANX is located at the end of the ARCNET bus.
ON = RS-232 115.2 kbits/sec
OFF = defined by CAMWorks™
(See Section 4)
To FocalPoint or TCP/IP Network Port
Green LED-Communication link established
(blinks with message traffic)
Yellow LED-100 Mbps speed (Off - 10 Mbps)
Connects to J5 of the next ILI-E3, ILI95-E3 Series or ANX
Connects to J10 of the RPT-E3
Connects to J2 from the previous ILI-E3, ILI95-E3 Series or
ANX
Network Reconfiguration
Network Reconfiguration originating from this node
Node's Network Address is duplicated at another node
Node is transmitting data to the network
Node is receiving data from the network
Node is resetting
General Network Fault
Table 3.7.6.1.1 ANX-SR Wiring Connections
E3 Series Installation/Operation Manual — P/N 9000-0574:I 11/04/10
Addressable Node Expander (ANX) Connections
Comments
RS-232 Download
or Printer Port