Siemens LMV5 Series Technical Instructions page 21

LMV Series
For O trim, the following CANbus module is required to connect the O
2
PLL52.110A100
The following O sensor is necessary for running O
2
information on the O sensor, see Document No. P7842.
2
QGO20.000D17
A flue gas collector is required to mount the O
as described below.
AGO20.001SDS-KT
AGO20.002LDS-KT
AGO20.001A
AGO20.002A
SCC Inc.
O2 Trim Components
O2 Module – Qty (1) Required for O2 Trim
Module to connect O
with (6) M16 to 1/2" NPT conduit adapters
compatible with liquid tight conduit fittings
O2 Sensor – Qty (1) Required for O2 Trim
O sensor, internally heated, zirconium dioxide
2
measuring cell, supplied with (2) M16 to 1/2" NPT
conduit adapters compatible with liquid tight fittings
Max. flue gas temperature: 575 °F
Flue Gas Collector – Qty (1) Required for O2 Trim
2
Weldless flue gas collector, 7.25" long, to be
mounted into stacks 12-16" in diameter, not to be
used on rectangular stacks
Weldless flue gas collector, 10.5" long, to be
mounted into stacks 18-36" in diameter, not to be
used on rectangular stacks
Flue gas collector, 7.25" long, to be welded into
stacks up to 16" in diameter
Flue gas collector, 10.5" long, to be welded into
stacks larger than 16" in diameter
Page 17
HOME
2
sensor to an LMV52, supplied
2
trim on an LMV52. For technical
2
sensor in the stack. Four options are available
Technical Instructions
Document No. LV5-1000
sensor to the LMV52.
Section 1