Connected Via Ethernet (Only 840D Sl) - Siemens SINUMERIK 840D sl Function Manual

Machine data
MD11350 $MN_HANDWHEEL_SEGMENT[3]
MD11351 $MN_HANDWHEEL_MODULE[3]
MD11352 $MN_HANDWHEEL_INPUT[3]
MD11350 $MN_HANDWHEEL_SEGMENT[4]
MD11351 $MN_HANDWHEEL_MODULE[4]
MD11352 $MN_HANDWHEEL_INPUT[4]
MD11350 $MN_HANDWHEEL_SEGMENT[5]
MD11351 $MN_HANDWHEEL_MODULE[5]
MD11352 $MN_HANDWHEEL_INPUT[5]
Logical base addresses:
Machine data
MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS [0]
MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS [1]
MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS [4]
MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS [5]
4.15.5

Connected via Ethernet (only 840D sl)

Parameter setting
The parameters for handwheels connected via Ethernet modules, e.g. machine control panel
"MCP 483C IE", "HT 8", or "HT 2", are assigned in the following NC machine data:
● MD11350 $MN_HANDWHEEL_SEGMENT[< x - 1 >] = 7
When connected via Ethernet modules, the segment always has to be entered as 7
(Ethernet).
● MD11351 $MN_HANDWHEEL_MODULE[< x - 1 >] = 1
When connected via Ethernet modules, the module always has to be entered as 1.
● MD11352 $MN_HANDWHEEL_INPUT[< x - 1 >] = y
where y = 1, 2, 3, etc. (handwheel interface at the Ethernet bus)
where x = 1, 2, 3, etc. (handwheel number in the NC)
Extended Functions
Function Manual, 10/2015, 6FC5397-1BP40-5BA3
Val‐ Meaning
ue
0 No handwheel parameterized
0 No handwheel parameterized
0 No handwheel parameterized
5th handwheel in the NCK
5 Hardware segment: PROFIBUS
6 Reference to logical base address of the handwheel slot of the
3rd MCP
1 1st handwheel in the handwheel slot
6th handwheel in the NCK
5 Hardware segment: PROFIBUS
5 Reference to logical base address of the handwheel slot of the
4th MCP
2 2nd handwheel in the handwheel slot
Value Meaning
288 Logical base address handwheel slot 1st MCP
304 Logical base address handwheel slot 2nd MCP
330 Logical base address handwheel slot 4th MCP
320 Logical base address handwheel slot 3rd MCP
H1: Manual and handwheel travel
4.15 Start-up: Handwheels
237