Siemens SINUMERIK 840D sl Function Manual page 234

H1: Manual and handwheel travel
4.15 Start-up: Handwheels
The parameter assignment of the third handwheel is performed in the following NCK machine
data:
● MD11350 $MN_HANDWHEEL_SEGMENT[ 2 ] = 5
● MD11351 $MN_HANDWHEEL_MODULE[ 2 ] = 1
● MD11352 $MN_HANDWHEEL_INPUT[ 2 ] = 1
Requirement
Operation of the control with default data (machine data, STEP 7 configuration).
Example
Parameterization of three handwheels, connected via PPU and an "MCP 483C PN" machine
control panel.
Handwheel number
in NCK
1
2
3
Parameterizing in the NCK machine data:
Machine data
MD11350 $MN_HANDWHEEL_SEGMENT[0]
MD11351 $MN_HANDWHEEL_MODULE[0]
MD11352 $MN_HANDWHEEL_INPUT[0]
MD11350 $MN_HANDWHEEL_SEGMENT[1]
MD11351 $MN_HANDWHEEL_MODULE[1]
MD11352 $MN_HANDWHEEL_INPUT[1]
MD11350 $MN_HANDWHEEL_SEGMENT[2]
MD11351 $MN_HANDWHEEL_MODULE[2]
MD11352 $MN_HANDWHEEL_INPUT[2]
234
Machine data set
(Index)
0
1
2
Val‐ Meaning
ue
1st handwheel in the NCK
2 Hardware segment: 8xxD_HW
1 ---
1 1st handwheel in the handwheel slot
2nd handwheel in the NCK
2 Hardware segment: 8xxD_HW
1 ---
2 2nd handwheel in the handwheel slot
3rd handwheel in the NCK
5 Hardware segment: PROFIBUS
1 Reference to logical base address of the handwheel slot of the
MCP
1 1st handwheel in the handwheel slot
Connection
PPU, 1st handwheel in the handwheel slot
PPU, 2nd handwheel in the handwheel slot
MCP, 1st handwheel in the handwheel slot
Function Manual, 10/2015, 6FC5397-1BP40-5BA3
Extended Functions