Tc_Tpg9; Definition Of Additional Parameters $Tc_Tpc1 - Siemens SINUMERIK 840D sl Function Manual

Figure 18-2
Note
The tool lengths are not automatically compensated when the angle is altered.
Note
On inclined axis machines the same angle must be specified for the inclined axis and the
inclined wheel.
18.1.3.8

$TC_TPG9

The parameter $TC_TPG9 specifies which correction values are to be used for the GWPS
calculation and tool monitoring for minimum wheel radius ($TC_TPG3), e.g.:
$TC_TPG9 = 3
$TC_TPG9 = 4
$TC_TPG9 = 5
$TC_TPG9 = 6
18.1.3.9

Definition of additional parameters $TC_TPC1 ... 10

For user-specific tool data, the additional parameters $TC_TPC1 to $TC_TPC10 can be set
up independent of the tool type via the following memory-configuring machine data:
Extended Functions
Function Manual, 10/2015, 6FC5397-1BP40-5BA3
Machine with inclined infeed axis
Length 1 (geometry + wear + base, depending on tool type)
Length 2 (geometry + wear + base, depending on tool type)
Length 3 (geometry + wear + base, depending on tool type)
Radius
W4: Grinding-specific tool offset and tool monitoring
18.1 Grinding-specific tool data
851