Manual And Handwheel Travel (H1); Signals From Nc (Db10) - Siemens SINUMERIK 840D sl Function Manual

Z2: NC/PLC interface signals

19.3 Manual and Handwheel Travel (H1)

19.3 Manual and Handwheel Travel (H1)
19.3.1

Signals from NC (DB10)

DB10
DBB97, 98, 99 Channel number geometry axis for handwheel 1, 2, 3
Edge evaluation: No
Significance of signal The operator can assign an axis to the handwheel (1, 2, 3) directly on the operator panel front. If this
axis is a geometry axis (IS "Machine axis" = 0), the assigned channel number for the handwheel in
question is transferred to the PLC.
In this way, the IS "Activate handwheel" is set for the selected geometry axis in accordance with the
state set by the operator (IS "Handwheel selected").
The following codes apply to the channel number:
With machine axes (IS "Machine axis" = 1), the IS "Channel number geometry axis for handwheel
1, 2, 3" has no meaning.
For further information, see IS "Axis number for handwheel 1, 2, 3".
Corresponding to .... DB10 DBB100 ff (axis number for handwheel 1, 2, 3)
DB10 DBX100.6 ff (handwheel selected)
DB10 DBX100.7 ff (machine axis)
DB21, ... DBX12.0 - 12.2 ff (activate handwheel)
Application exam‐ If DB10 DBB97 = 2, then handwheel 1 is assigned to channel 2.
ple(s)
896
Signal(s) updated: Cyclic
7 6 5
0 0 0
0 0 0
0 0 0
Bit
4 3 2
0 0 0
0 0 0
0 0 0
Function Manual, 10/2015, 6FC5397-1BP40-5BA3
Channel number
1 0
0 0
0 1
1 0
Extended Functions
-
1
2