Location Of The Port Openings On The Chassis; Aligning The Ethernet Adapter Port Connectors - IBM Storwize V7000 Unified Series Problem Determination Manual

2
2
1
3
1
Figure 15. Location of the port openings on the chassis
10. Align the adapter with the adapter connector on the system board; then, tilt
Ethernet
adapter connector
Figure 16. Aligning the Ethernet adapter port connectors with the port openings
11. Slide the port connectors on the adapter into the port openings on the chassis;
8. While you slightly press the top of the metal clip, rotate the metal clip toward
the front of the server until the metal clip clicks into place. Make sure the
metal clip is securely engaged on the chassis.
Attention: Pressing the top of the metal clip with excessive force may cause
damage to the metal clip.
9. Touch the static-protective package that contains the new Ethernet adapter to
any unpainted metal surface on the server. Then, remove the Ethernet adapter
from the package.
the adapter so that the port connectors on the adapter line up with the port
openings on the chassis. See Figure 16.
1
Standoff
2
then, press the adapter firmly until the two standoffs engage the adapter.
Make sure the adapter is securely seated on the connector on the system
board.
Make sure the port connectors on the adapter do not set on the rubber
stopper. The following illustration shows the side view of the adapter in the
109
Chapter 4. File module