IBM Storwize V7000 Unified Series Problem Determination Manual page 295

Table 46. Upgrade error codes and recommended actions (continued)
Error
Code Explanation
01D3 Could not determine if backups are
running.
01D5 Storwize V7000
stalled_non_redundant.
01D6 Storwize V7000 system stalled.
01D8 CTDB system is unhealthy.
01DA GPFS system is unhealthy.
01DB Failed to stop performance center.
01DC Failed to configure performance
center.
01DD Failed to start performance center.
01DE Unable to communicate with
passive management node.
01DF Upgrade must be resumed from the
other management node.
01E0 HSM upgrade failed.
Action
Type lsjobstatus -j backup;echo $?. If
the return code is 0, start the upgrade
again. If the return code is any other
number, contact your next level of
support.
Contact your next level of support.
Contact your next level of support.
See "Checking CTDB health" on page
160.
See "Checking the GPFS file system
mount on each file module" on page 162.
Contact your next level of support.
Contact your next level of support.
Contact your next level of support.
Verify that the other management node is
up and that TCP/IP communication is
working. Then start the upgrade again.
Start the upgrade again from the other
management node. This might require
that a failover be issued first.
Contact your next level of support.
Chapter 7. Recovery procedures
271