Va Safety Cover; Installing The 240 Va Safety Cover - IBM Storwize V7000 Unified Series Problem Determination Manual

Screw
Safety cover
Alignment
tabs
Figure 44. 240 VA safety cover
7. Disconnect the hard disk drive backplane power cables from the connector in
8. Slide the cover forward to disengage it from the system board, and then lift it
9. If you are instructed to return the 240 VA safety cover, follow all packaging

Installing the 240 VA safety cover

The following procedure is for a field replaceable unit (FRU). FRUs must be
installed only by trained service technicians.
To install the 240 VA safety cover, perform the following steps:
1. Line up and insert the tabs on the bottom of the safety cover into the slots on
154
Storwize V7000 Unified: Problem Determination Guide Version
front of the safety cover.
out of the server.
instructions, and use any packaging materials for shipping that are supplied to
you.
the system board. See Figure 45 on page 155.