Replacing A Control Enclosure Chassis - IBM Storwize V7000 Unified Series Problem Determination Manual

Figure 64. SAS cable
3. Plug the replacement cable into the specific port.
4. Ensure that the SAS cable is fully inserted. A click is heard when the cable is
successfully inserted.

Replacing a control enclosure chassis

This topic describes how to replace a control enclosure chassis.
Note: Ensure that you know the type of enclosure chassis that you are replacing.
The procedures for replacing a control enclosure chassis are different from those
procedures for replacing an expansion enclosure chassis. For information about
replacing an expansion enclosure chassis, see "Replacing an expansion enclosure
chassis" on page 235.
229
Chapter 5. Control enclosure