Serveraid M5000 Advanced Feature Key And; Removing The Serveraid Sas Controller Battery From The Remote Battery Tray - IBM Storwize V7000 Unified Series Problem Determination Manual

ServeRAID M5000
advanced feature key
Figure 31. ServeRAID M5000 advanced feature key and M5014 adapter
5. Reconnect the power cord and any cables that you removed.
6. Install the cover, as described in Installing the cover.
7. Slide the server into the rack.
8. Turn on the peripheral devices and the server.
Removing the serveRAID SAS controller battery from the remote
battery tray
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 51.
To remove a serveRAID SAS controller battery from the remote battery tray,
complete the following procedure.
1. To help you work safely with Storwize V7000 Unified file modules, read the
2. Turn off the file module and peripheral devices, then label and disconnect both
3. Press down on the left and right side latches and pull the server out of the rack
4. Remove the cover, as described in "Removing the cover" on page 83.
124
Storwize V7000 Unified: Problem Determination Guide Version
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 54.
power cords and all external cables.
enclosure until both slide rails lock.
ServeRAID-M5014
adapter