Installing An Ioc Or Spc - Juniper SRX5600 Installation And Initial Configuration Manual

Installing an IOC or SPC

• Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD
points on the chassis.
• Place the card on an antistatic mat or remove it from its antistatic bag.
• Verify that each fiber-optic interface has a rubber safety cap covering the transceiver. If it
is not covered, cover the transceiver with a safety cap.
• Locate the slot in the card cage in which you plan to install the IOC or SPC. If necessary, Locate the slot in the card cage in which you plan to install the IOC or SPC. If necessary,
remove the blank plate.
© 2010 Juniper Networks, Inc. All rights reserved.
CONFIDENTIAL
www.juniper.net | 115
FSSSRX5800