Removing a Switch Control Board
To remove an SCB, follow this procedure:
• Place an electrostatic bag or antistatic mat on a flat, stable surface.
• Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD
points on the chassis.
• Disconnect any cables that may be connected to ports on the RE.
• Simultaneously rotate the ejector handles counterclockwise to unseat the SCB
• Simultaneously rotate the ejector handles counterclockwise to unseat the SCB.
• Grasp the ejector handles and slide the SCB about halfway out of the chassis.
CONFIDENTIAL
www.juniper.net | 73
© 2010 Juniper Networks, Inc. All rights reserved.
FSSSRX5800