Operation - Polaris 800 INDY XC 129 2019 Owner's Manual

OPERATION

STARTING THE ENGINE
Engaging the starter when the engine is running WILL result in serious engine
damage, especially if the engine is in reverse. Never engage the starter when
1. Turn the key to the ON position.
2. Pull the engine stop switch up to the RUN position.
3. If equipped with electric start, turn the key to START to crank the engine.
Release the key to the ON position when the engine starts.
4. If not equipped with electric start, grasp the starter handle and pull slowly
until the recoil engages; then pull abruptly to crank the engine.
5. If the engine does not start after several attempts, slightly depress the
throttle no more than 1/4 inch (2.54 cm) open while cranking the engine.
When the engine starts, immediately release the throttle.
To avoid injury and/or engine damage, do not operate the electric starter or
Operating the vehicle immediately after cold starting could cause engine
damage. Allow the engine to warm up for several minutes before operating the
vehicle. If cold drive-away is attempted, the engine RPM may stumble slightly
RESTARTING AN ENGINE
If the rider stops the engine by pushing the engine stop switch down, restart the
engine using the normal starting procedure. If the engine fails to start using the
normal procedure:
1. Push the engine stop switch down to the OFF position.
2. Turn the key to the OFF position.
3. With both switches OFF, squeeze and hold the throttle in the wide open
position.
4. Crank the engine several times to clear the engine.
CAUTION
the engine is running.
CAUTION
pull-rope starter while the engine is running.
to protect the engine.
NOTICE
OPERATION
87