Polaris 800 INDY XC 129 2019 Owner's Manual page 116

MAINTENANCE
4. Finger tighten the adjuster bolt
then back off 1/4 turn.
5. Tighten the jam nut while holding the adjuster bolt.
6. Reinstall the side panels.
7. Release the brake lever lock.
BRAKES
HYDRAULIC BRAKE INSPECTION
Inspect the brake lever reserve before each use of the snowmobile. See page
83.
Brake pads must be replaced when the brake pad material becomes thinner
than the backing plate (approximately 1/16 inch or 1.5 mm). A kit is available for
replacing brake pads. Your POLARIS dealer can assist.
Brake failure during operation can result in serious injury or death. Properly
functioning brakes are vital to your safety. Be sure the brake pads do not drag
on the disc and that brake lever travel is not excessive. Always replace brake
pads when the brake pad material becomes thinner than the backing plate
BRAKE COMPONENTS
q
Brake Caliper
w
Brake Disc
e
Brake Pad Material - Replace when
thickness is less than 1/16 inch (1.5
mm).
114
w
until it can no longer be adjusted by hand,
TORQUE
21 ft. lbs. (28 Nm)
WARNING
(approximately 1/16 inch or 1.5 mm).