COMPONENT
Not
Hand Guard Mounts (if applicable)
Shown
Not
Mountain Hoop Bar (if applicable)
Shown
HANDLEBAR ANGLE
Handlebar angle can be adjusted to suit rider preference.
1. Loosen the four bolts on the top riser block
2. Adjust the handlebar upward or downward to the desired angle. Be sure the
handlebar, brake lever and throttle lever operate smoothly and do not hit the
gas tank, windshield or any other part of the machine when turned fully to the
left or right. If necessary, loosen the set screws for the left and right controls,
rotate the controls slightly, then tighten the set screws to the proper torque.
Do not stretch wires while adjusting the controls. Stretching the wires could
3. Tighten the bolts.
NOTICE
damage the handwarmers.
TORQUE
14.8 ft-lbs (20 Nm)
THE PERFECT FIT
TORQUE
DO NOT OVER-TIGHTEN
Hand-Tight
10 ft-lbs (13.6 Nm)
q
.
73