Table of Contents
Advertisement
MAINTENANCE
5. Using an 8 mm wrench, loosen the air bleed screw
the coolant outlet elbow. Use a shop towel to catch any coolant that leaks
from the bleeder. Tighten the screw after a steady stream of coolant flows
from the bleeder.
6. Fill the coolant bottle to the COLD FILL mark.
7. Install the coolant bottle cap to the first lock. Do not tighten to the fully seated
position.
8. Lock the parking brake.
9. Start the engine and allow it to run at a fast idle for several minutes, until the
heaters are warm to the touch. Loosen the bleed screw occasionally to purge
any trapped air.
10. When all heater extrusions are warm to the touch, stop the engine.
11. Allow the engine and cooling system to cool. Secure the bleed screw.
12. Fill the coolant bottle to the COLD FILL mark. Reinstall the bottle cap
securely.
13. Carefully lower the front end of the snowmobile.
14. Open the side panels and reinstall the hood. Close the side panels.
112
q
located on the top of
Hide quick links:
Advertisement
Table of Contents
