Polaris 800 INDY XC 129 2019 Owner's Manual page 133

8. Secure the right fender using the plastic rivet.
9. Reinstall the console using the two plastic rivets.
10. Reinstall the side panel.
BATTERY STORAGE
Whenever the vehicle is not used for a period of three months or more, remove
the battery from the vehicle, ensure that it's fully charged, and store it out of the
sun in a cool, dry place. Check battery voltage each month during storage and
recharge as needed to maintain a full charge.
Battery charge can be maintained by using a POLARIS Battery Tender
charger or by charging about once a month to make up for normal self-
discharge. Battery Tender
and will automatically charge the battery if the voltage drops below a pre-
BATTERY CHARGING
The following battery charging instructions apply only to the installation of a
sealed battery. Read all instructions before proceeding with the installation of
this battery.
The sealed battery is already filled with electrolyte and has been sealed and fully
charged at the factory. Do not ever pry the sealing strip off or add any other fluid
to this battery.
The single most important thing about maintaining a sealed battery is to keep it
fully charged. Since the battery is sealed and the sealing strip cannot be
removed, you must use a voltmeter or multimeter to measure DC voltage.
For a refresh charge, follow all instructions carefully.
1. Check the battery voltage with a voltmeter or multimeter. A fully charged
battery will register 12.8 V or higher.
2. If the voltage is less than 12.8 volts, recharge the battery at 1.2 amps or less
until the battery voltage is 12.8 or greater.
When using an automatic charger, refer to the charger manufacturer's
instructions for recharging. When using a constant current charger, use the
TIP
TM can be left connected during the storage period,
determined point.
RESTRICTION
following guidelines for recharging.
MAINTENANCE
TM
131