THE PERFECT FIT
4. Tighten the screws to specification in the sequence shown in the image. Do
not over-torque.
5. Return the master cylinder to its specified position. Make sure the clamp will
not pinch the brake light signal wire. Tighten the clamp screws to
specification beginning with the front screw first, then the screw next to
reservoir. Do not over-torque.
HANDLEBAR COMPONENTS
Refer to the following illustration and measurements to position handlebar
components at factory-specified locations.
q
.011 in. (3 mm)
w
6.65 in. (169 mm)
e
6.7 in. (170 mm)
76
TORQUE
24 in-lbs (2.7 Nm)
TORQUE
70 in-lbs (7.9 Nm)
r
10 in. (254 mm)
t
.47 in. (12 mm)
y
.08 in. (2 mm)