Machine Parameter Cleaning - WAGNER PXM Operating And Assembly Manual

VERSION 08/2015
OPERATING AND ASSEMBLY MANUAL
7.7.3

MACHINE PARAMETER CLEANING

The settings in the "Cleaning" machine parameters can be optimized for customer-specific
requirements.
Communication with the application controller
Yes
Interface
Settings
Parameter:
Communication with the
application controller
Pre-cleaning
Block 1
Standard
Interface
Settings
ORDER NUMBER DOC2350372
No
FP RP
Injectors
supply supply
MP
MP
Diagnosis
cleaning
operation
Explanation:
Yes: The powder center controller communicates with the
application controller
In doing so, the following information is exchanged in
conjunction with MCC, Profi Tech M or S Profi Tech:
- Move the guns to the cleaning position for internal cleaning
- Switch on the gun air during internal cleaning
- Switch off the gun air after internal cleaning fi nishes
No: The powder center controller does not communicate
with the application controller
Cleaning
Block 2 Block 1 Block 2
Standard
FP RP
Injectors
supply supply
MP
MP
Diagnosis
cleaning
operation
Home page
Cleaning
Settings
US sieve
System
Alarm
Dynamics
Home page
Off
On
Cleaning
Settings
US sieve
System
Alarm
PXM
62