Identification; Explosion Protection Identification; Permissible Device Combinations; Type Plate - WAGNER PXM Operating And Assembly Manual

VERSION 08/2015
OPERATING AND ASSEMBLY MANUAL
3

IDENTIFICATION

3.1

EXPLOSION PROTECTION IDENTIFICATION

The PXM powder center is intended for construction outside of the dust Ex-zone (Zone 22).
3.2

PERMISSIBLE DEVICE COMBINATIONS

The following components may be used in the PXM powder center:
PI-F1 injector
Hi-Coat ED injector
Ultrasonic screening device (version for PXM with replaceable fi lter)
IP 5000 powder pump
EPG S2 control unit
EPG-Sprint X control unit
MCC controller
MCS 1 controller
CPD 1
3.3

TYPE PLATE

Powder center
P_02627
Note:
The type plate may only be attached with the CE mark if the complete installation
(powder center, controller, add-on parts, etc.) complies with the provisions of the
EC directives.
ORDER NUMBER DOC2350372
P_02628
Control cabinet
PXM
12