Machine Parameters Operation - WAGNER PXM Operating And Assembly Manual

VERSION 08/2015
OPERATING AND ASSEMBLY MANUAL
7.7.2

MACHINE PARAMETERS OPERATION

The settings in the "Operation" machine parameters are normally not changed since they
are defined by the installed hardware.
Fault trigger delay powder
shortage
WS cylinder lowering
Feeding rate [sec]
WS cylinder lowering
Break time [sec]
Time setting for level
controller [sec]
Work-
station
Settings
Parameter:
Fault trigger delay powder
shortage
WS cylinder lowering
Feeding rate [sec]
WS cylinder lowering
Break time [sec]
Time setting for level
controller [sec]
ORDER NUMBER DOC2350372
FP RP Exhaust
supply supply system
MP MP
Diagnosis
operation cleaning
Explanation:
Delay time after which an error message is triggered in
the case of powder shortage
Period of time in which the workstation cylinder is
supplied with compressed air during raising and lowering
Period of time in which the workstation cylinder is not
supplied with compressed air during raising and lowering
Delay time after which the linear motion unit lowered
during a powder shortage and the fresh powder pump
is switched on
Standard
Home page
Cleaning
Settings
System
Alarm
PXM
56