Control Panel - Hoshizaki KM-340MAH Manual

Need Service or Repair? Locate your closest Hoshizaki Certified Service Tech: hoshizakiamerica.com/locate-service-rep
After 30 minutes, remove Front Panel, then move the A
8
control switch to OFF.
NOTICE! DO NOT leave the control switch on WASH
for extended periods when water tank is empty. It will
damage water pump seals.
Remove the Pump Tubing. Clean all items (See R
9
S Step 10). Once water tank has drained, replace and
reconnect all the items.
I In bad water conditions, a more thorough cleaning may
10
b be required. Turn off power supply, clean all items in a
solution of 5 oz. of Scale Away per gallon of warm
water. Rinse and replace the cube guides, float switch,
water supply tubes, spray tubes and spray guides. Turn
on power supply. Otherwise, continue to Step
Cleaning Rinse:
Turn the cleaning valve to the right until completely T
11
horizontal (closed). Move the control switch to ICE, h
replace Front Panel. After 3 minutes, remove the
Front Panel, move switch to OFF.
NOTICE! ICE MACHINE WILL NOT WORK,
unless valve is completely closed.
T Turn the cleaning valve to the left until completely
12
vertical (open). Move the control switch to WASH,
replace the Front Panel. After 5 minutes, remove
the Front Panel, switch to OFF.
Disconnect the Pump Tubing. After the water tank D
13
h has drained, reconnect Pump Tubing. Continue to
Sanitation – Step on front...
OPEN cleaning valve:
To allow cleaning solution flow to
the inside the evaporator
Turn left to open (vertical)
DOWNLOAD COMPLETE
INSTRUCTION MANUAL:
hoshizakiamerica.com/support
Type in the model number of your
ice machine (including dashes) to
download manuals
#51001 | 7.22.2016
.
ICE
WASH
Scoop Dish soap, rinse well
Water Filters
Check psi, change if req'd
Exterior
Dish soap & damp cloth
Bin Door/Top Kit
Warm water & clean cloth
Ice Maker/Bin
Follow these instructions
Water Supply Inlet
Clean inlet screen
Condenser
Inspect. Clean with brush
Water Hoses
Inspect. Replace if req'd
Tech Support: 1.800.233.1940
30
min.
CLOSE

CONTROL PANEL

OFF
> 3 minutes >
OPEN
CONTROL PANEL
OFF
> 5 minutes >
CLOSE cleaning valve:
Must be closed for normal ice
making operation
Turn right to close (horizontal)
WARNING!
DO NOT use
ammonia type
cleaners. Can cause
damage to icemaker
WEAR liquid-proof
gloves and goggles to
protect skin & eyes
from cleaning &
sanitizing chemicals
sanitizing continued...
RINSE 1:
(Steps 19-21)
CLOSE cleaning valve
Move control switch to ICE,
replace the front panel
After 3 minutes, remove the
front panel
Move control switch to OFF
OPEN cleaning valve
Move control switch to WASH,
replace the front panel
After 5 minutes, remove the
front panel
Move control switch to OFF
Disconnect the pump
tubing
After the water tank has
drained, reconnect the pump
tubing
RINSE 2 & 3:
(Steps 22-28)
Repeat 2x (Steps 19–21) for
complete ice/food safety
Clean the dispenser /
storage bin liner with a
neutral cleaner (dish soap)
Rinse thoroughly
CLOSE cleaning valve
Move control switch to ICE,
replace front panel
Replace all panels in their
correct positions
NOTICE!
IF ICE MAKER IS ON DISPENSER,
remember to turn on the dispenser
after cleaning
AMMONIA
Cleaners
19
20
21
22
29
30
Page 3