Setup; Dispenser Unit/Ice Storage Bin Setup; Bin Control Installation - Hoshizaki KML-325MAJ Instruction Manual

D. Setup

1. Dispenser Unit/Ice Storage Bin Setup

Confirm the front, top, and right side panels are removed from the icemaker.
The installer must ensure the dispenser unit/ice storage bin is compatible with
the icemaker, and the dispenser unit/ice storage bin and icemaker are properly
attached and secured.
1a) Dispenser Unit: Follow the dispenser unit's setup procedure.
1b) Ice Storage Bin: Unpack the ice storage bin and attach the 4 adjustable legs provided
(bin accessory) to the bottom of the ice storage bin.
2) Position the dispenser unit/ice storage bin in its permanent location.
3) If required, install an adapter kit or top kit. Contact your local Hoshizaki distributor for
recommendations.
4) Level the dispenser unit/ice storage bin in both the left-to-right and front-to-rear
directions. If using an ice storage bin, adjust the ice storage bin legs to level.

2. Bin Control Installation

5) Remove the bin control, thumbscrews, and bin control bracket from the accessory bag.
6) Using the 2 thumbscrews secure the bin control to the bin control bracket.
7a) No Top Kit Application: Place the bin control assembly 4-1/2 in. (115 mm) from the
left side of the dispenser or ice storage bin on the rear section of the dispenser or
ice storage bin. See Figs. 2a, 2b, and 2c. Using the 2 self-drilling screws from the
accessory bag, secure the bin control bracket to the dispenser or ice storage bin.
Bin Control Bracket
Bin
Bin Control
Control
Assembly
Bin Control
Assembly
Thumbscrews
Dispenser
Fig. 2c
WARNING
Fig. 2a
Bin Control
Bracket
Dispenser/Ice Storage Bin
Bin Control
Bin Control Assembly
Bracket
Bin Control
Assembly
Thumbscrews
Ice Storage Bin
Self-Drilling Screws
Rear View
14
Fig. 2b