Bin Control Installation - Hoshizaki KM-1301SRJZ/3 Instruction Manual

2. Bin Control Installation

Before operating the icemaker, the bin control must be installed. Failure to properly
install the bin control could result in ice backup and icemaker damage.
1) Remove the baffle from the storage bin.
2) Remove the thumbscrew and bin control assembly from inside the icemaker. See Fig. 3.
3) Use the thumbscrew removed in the previous step and the thumbscrew included in the
accessory bag to secure the bin control assembly to the bottom of the icemaker. See
Fig. 4.
4) Remove the bin control cable bracket from inside the icemaker, then route the bin
control cable through the hole in the bottom of the icemaker and the bushing in the
bin control cable bracket. Secure the bin control cable bracket. Leave as little slack as
possible inside the storage bin. Route the cable through the wire saddles.
Bin Control Assembly
Thumbscrew
Fig. 3
NOTICE
Connection Overview
Wire Harness
Bin Control Cable Connector to
Connector B
Wire Harness Connector A
(for upper unit)
Bin Control Bracket
Bin Control Assembly
Thumbscrews
Connection Detail
Wire Harness Connector B
(for upper unit)
Bin Control Cable Connector
19
Wire Harness
Control Board
Red K4 Connector
Wire Saddle
Bin Control
Cable Bracket
Bin Control Cable
Wire
Harness
Connector A
Control Board
Red K4 Connector
Fig. 4