Hoshizaki KM-340MAH Manual page 13

Need Service or Repair? Locate your closest Hoshizaki Certified Service Tech: hoshizakiamerica.com/locate-service-rep
After 30 minutes, remove Front Panel, then move the control switch to OFF. A
8
Remove the Front Insulation Panels. Remove the Drain Plug. Clean all items (See R
9
Step 10). Once the water tank has drained, replace the Drain Plug and Insulation S
Panel.
In In bad water conditions, a more thorough cleaning
10
may be required. Turn off power supply, clean all items
in a solution of 5 oz. of Scale Away per gallon of
warm water. Rinse and replace the cube guides, float
switch, water supply tubes, spray tubes and spray
guides. Turn on power supply. Otherwise, continue to
step .
Cleaning Rinse:
T Turn the cleaning valve to the right until completely
11
h horizontal (closed). Move the control switch to ICE,
replace Front Panel. After 3 minutes, remove the
Front Panel, move switch to OFF.
NOTICE! ICE MACHINE WILL NOT WORK,
unless valve is completely closed.
Turn the cleaning valve to the left until completely T
12
vertical (open). Move the control switch to WASH, v
replace the Front Panel. After 5 minutes, remove
the Front Panel, switch to OFF.
R Remove the Front Insulation Panel. Remove the
13
D Drain Plug. Once the water tank has drained,
replace the Drain Plug and Insulation Panel.
Continue to Sanitation – Step
OPEN cleaning valve:
To allow cleaning solution flow to
the inside the evaporator
Turn left to open (vertical)
hoshizakiamerica.com/support
Type in the model number of your
ice machine (including dashes) to
download manuals
#51005 | 7.22.2016
ICE
WASH
on front...
Scoop
Dish soap, rinse well
Water Filters
Check psi, change if req'd
Exterior
Dish soap & damp cloth
Bin Door/Top Kit
Warm water & clean cloth
Ice Maker/Bin
Follow these instructions
Water Supply Inlet
Clean inlet screen
Condenser
Inspect. Clean with brush
Water Hoses
Inspect. Replace if req'd
Tech Support: 1.800.233.1940
CLOSE
CONTROL PANEL
OFF
> 3 minutes >
OPEN
CONTROL PANEL
OFF
> 5 minutes >
CLOSE cleaning valve:
Must be closed for normal ice
making operation
Turn right to close (horizontal)
WARNING!
DO NOT use
ammonia type
cleaners. Can cause
damage to icemaker
WEAR liquid-proof
gloves and goggles to
protect skin & eyes
from cleaning &
sanitizing chemicals
sanitizing continued...
RINSE 1:
(Steps 19-21)
CLOSE cleaning valve
Move control switch to ICE,
replace the front panel
After 3 minutes, remove the
front panel
Move control switch to OFF
OPEN cleaning valve
Move control switch to WASH,
replace the front panel
After 5 minutes, remove the
front panel
Move control switch to OFF
Remove the front
insulation panel
Remove drain plug
After the water tank has
drained, replace and reconnect
all the items
RINSE 2 & 3:
(Steps 22-27)
Repeat 2x (Steps 19–21) for
complete ice/food safety
Clean the dispenser /
storage bin liner with a
neutral cleaner (dish soap)
Rinse thoroughly
CLOSE the cleaning valve
Move control switch to ICE
Replace all panels
NOTICE!
IF ICE MAKER IS ON DISPENSER,
remember to turn on the dispenser
after cleaning
AMMONIA
Cleaners
19
20
21
22
28
29
30
Page 13