Toshiba e-STUDIO 281C Printing Manual page 294

3. Printing
NOTE: This option cannot be selected if a hole punch unit is not installed.
3) Stapling
294
- Long Edge Punch with 180 degree rotation — Select this to create holes on
the right side for the portrait document, or on the bottom for the landscape docu-
ment.
- Short Edge Punch with 180 degree rotation — Select this to create holes on
the bottom for the portrait document, or on the left for the landscape document.
This sets whether a print job is stapled.
- Off — Select this to print without stapling.
- Upper Left (Portrait)/Upper Right (Landscape) — Select this to staple in the
upper left for the portrait document, or in the upper right for the landscape docu-
ment.
- Middle Left (Portrait)/Middle Top (Landscape) — Select this to staple double
in the left for the portrait document, or in the top for the landscape document.
- Lower Left (Portrait)/Upper Left (Landscape) — Select this to staple in the
lower left for the portrait document, or in the upper left for the landscape docu-
ment.
Printing Guide — Printing from Macintosh