Genie Z-33/18 Operator's Manual page 31

First edition • First Printing
Test Limited Drive Speed
33 Press down the foot switch.
34 Raise the primary boom approximately 82 cm.
35 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not
exceed 24 cm/s.
36 Lower the primary boom to the stowed position.
37 Raise the secondary boom approximately 42
cm.
38 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the secondary boom raised should not
exceed 24 cm/s.
39 Lower the secondary boom to the stowed
position.
40 Extend the primary boom approximately 10 cm.
41 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 24 cm/s.
42 Retract the boom to the stowed position.
If the drive speed with the primary boom raised,
the secondary boom raised or the primary boom
extended exceeds 24 cm/s, immediately tag and
remove the machine from service.
43 Rotate the turntable until the primary boom
moves past one of the non-steer wheels.
44 Extend the primary boom approximately 10 cm.
45 Slowly move the drive control handle to the full
drive position.
Part No. 1257143
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 6.5 cm/s.
If the drive speed with the primary boom moved
past one of the non-steer wheels and the primary
boom extended exceeds 6.5 cm/s, immediately tag
and remove the machine from service.
Test Emergency Controls
46 Pull out the red Emergency Stop button to the
on position.
47 Press down the foot switch.
48 Simultaneously hold the emergency
power switch on and activate each
boom function toggle switch.
Note: To conserve battery power, test
each function through a partial cycle.
Result: All boom functions should operate. Drive
functions should not operate with auxiliary power.
Test the Lift/Drive Select Function
49 Press down the foot switch.
50 Move the drive control handle off center and
activate a boom function toggle switch.
Result: No boom functions should operate. The
machine will move in the direction indicated on
the control panel.
Repair any malfunctions before operating the
machine.
Z-33/18
Operator's Manual
Inspections
29