Work Area Safety - Genie Z-33/18 Operator's Manual

Operator's Manual

Work Area Safety

Electrocution Hazards
This machine is not electrically insulated and will not
provide protection from contact with or proximity to
electrical current.
ì Obey all local and
governmental regulations
regarding required
clearance from electrical
power lines. At a minimum,
the required clearance
contained in the chart
below must be followed.
Line Voltage
0 to 50KV
50 to 200KV
200 to 350KV
350 to 500KV
500 to 750KV
750 to 1000KV
Allow for platform movement, electrical line sway
or sag, and beware of strong or gusty winds.
Keep away from the
machine if it contacts
energized power lines.
Personnel on the ground
or in the platform must not
touch or operate the
machine until energized
power lines are shut off.
Do not operate the machine during lightning or
storms.
Do not use the machine as a ground for welding.
10
Occupants, equipment and materials shall not
exceed the maximum platform capacity or the
maximum platform capacity of the platform
extension.
Maximum platform capacity
Maximum occupants
The weight of options and accessories, such
as pipe cradles, panel cradles and welders, will
reduce the rated platform capacity and must be
subtracted from the platform capacity. See the
Required Clearance
decals with the options and accessories.
10 ft 3.05 m
15 ft 4.60 m If using accessories, read, understand and obey
the decals, instructions and manuals with the
20 ft 6.10 m
accessory.
25 ft 7.62 m
35 ft 10.67 m
Do not alter or disable the limit switches.
45 ft 13.72 m
Do not raise or extend the boom unless the
machine is on a firm, level surface.
Do not depend on the tilt alarm as a level indicator.
The tilt alarm sounds in the platform only when the
machine is on a severe slope.
Z-33/18
First edition • First Printing
Tip-over Hazards
Part No. 1257143
440 lbs /
200 kg
2