Genie Z-33/18 Operator's Manual page 23

First edition • First Printing First edition • First Printing
Platform Control Panel
1 Horn button
Press this button and the horn will sound.
Release the button and the horn will stop.
2 Secondary boom up/down switch
Move the switch up and
the secondary boom will
raise. Move the switch
down and the secondary
boom will lower.
3 Platform level switch
Move the platform level
switch up and the level
of the platform will raise.
Move the platform level
switch down and the level
of the platform will lower.
4 Platform overload indicator light
Light flashing indicates the platform is
overloaded and no functions will operate.
Remove weight until the light goes off.
5 Machine not level indicator light
Light is on when the platform is raised and
the machine is on a severe slope. The drive
function in one or both directions will not
operate.
6 Red Emergency Stop button
Push in the red Emergency Stop button to the
off position to stop all functions. Pull out the red
Emergency Stop button to the on position to
operate the machine.
Part No. 1257143
7 Proportional control handle for drive function and
thumb rocker for steer function
Move the control handle in the direction
indicated by the blue arrow on the control panel
and the machine will drive forward. Move the
control handle in the direction indicated by
the yellow arrow and the machine will drive
backwards.
Press the left side of the thumb rocker and the
machine will steer to the left. Press the right
side of the thumb rocker and the machine will
steer to the right.
8 Drive enable indicator light
Light on indicates that the boom has moved just
past either non-steer wheel and drive function
has been interrupted.
9 LCD Display
Display screen for system fault information and
battery charge level.
10 Drive enable switch
To drive when the drive enable light is on, hold the
drive enable switch to either side and slowly move
the drive control handle off center. Be aware that
the machine may move in the opposite direction
that the drive and steer controls are moved.
11 Boom function speed controller
Turn the dial to increase or decrease the speed
of the machine functions.
Z-33/18
Operator's Manual Operator's Manual
Controls
21