Installing The Cutting Units; Front Hose Guide (Right); Front Hose Guide (Left) - Toro Reelmaster 7000-D Operator's Manual

Figure 5
1. Hood-latch bracket
3. Remove the hood-latch bracket from the hood.
4. While aligning the mounting holes, position the
CE lock bracket and the hood-latch bracket onto
the hood.
Note:
The lock bracket must be against the
hood (Figure 5).
Do not remove bolt and nut assembly from the
lock-bracket arm.
Figure 6
1. CE lock bracket
5. Align the washers with the holes on the inside of
the hood.
6. Rivet the brackets and the washers to the hood
(Figure 6).
7. Hook the latch onto the hood-latch bracket
(Figure 7).
g012628
2. Rivets
g012629
2. Bolt and nut assembly
1. Hood latch
8. Screw the bolt into the other arm of hood-lock
bracket to lock the latch in position
1. Bolt
2. Nut
9. Tighten the bolt securely but do not tighten the
nut.
3

Installing the Cutting Units

Parts needed for this procedure:
1

Front hose guide (right)

1

Front hose guide (left)

Procedure
1. Remove the reel motors from the shipping
brackets.
2. Remove and discard the shipping brackets.
3. Remove the cutting units from the cartons.
13
Figure 7
(Figure
Figure 8
3. Arm of the hood-lock
bracket
g012630
8).
g012631