Notation for Areas of Concern
Inspection performed by:
Item
Date
1
2
3
4
5
6
7
8
Important:
Refer to your engine owner's manual and cutting unit Operator's Manual for additional
maintenance procedures.
Note:
Download a free copy of the electrical or hydraulic schematic by visiting www.Toro.com and searching
for your machine from the Manuals link on the home page.
Pre-Maintenance
Procedures
Removing the Hood
1.
Release the hood latches
open the hood.
Figure 78
1. Hood latch (2)
2.
Remove the cotter pins securing the rear hood
brackets to the frame pins and lift off the hood.
Information
(Figure
78) and pivot
Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that must be
lubricated regularly with No. 2 lithium grease. If
you operate the machine under normal conditions,
lubricate all bearings and bushings after every 50
hours of operation or immediately after every washing.
The grease fitting locations and quantities are as
follows:
•
Brake shaft pivot bearings (5)
g200373
•
Rear axle pivot bushings (2)
52
(Figure
79)
Figure 79
(Figure
80)
g009704