Adjusting The Support Rollers; Installing The Hood Lock For Ce Compliance; Procedure; No Parts Required - Toro Reelmaster 7000-D Operator's Manual

1
Adjusting the Support
Rollers

No Parts Required

Procedure

Depending on what width cutting units are to be
installed on the traction unit, adjust the support rollers
as follows:
Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove the
key.
•
If using 27 inch cutting units, install the rollers in
the upper mounting holes of the support assembly
channels (Figure 3).
•
If using 32 inch cutting units, install the rollers in
the lower mounting holes of support assembly
channels (Figure 3).
1. Support assembly channel 3. Use this hole for 32 inch
2. Use this hole for 27 inch
cutting units.
Figure 3
cutting units.
2
Installing the Hood Lock for
CE Compliance
Parts needed for this procedure:
1

Hood-lock bracket

2

Rivet

1

Screw (1/4 x 2 inch)

2

Flat washer (1/4 inch)

1

Locknut (1/4 inch)

Procedure
1. Unhook the hood latch from the hood-latch
bracket (Figure
1. Hood latch
g019541
2. Remove the 2 rivets securing the hood-latch
bracket to the hood
12
4).
Figure 4
(Figure 5).
g200373