Toro Reelmaster 7000-D Operator's Manual page 48

Figure 76
1. Reverse traction pressure
test port
3. Rotate the bypass valve 90° (1/4 turn) in either
direction to open it and allow fluid to bypass
internally (Figure
Note:
Because the fluid bypasses the
transmission, you can move the machine slowly
without damaging the transmission.
Note the position of the valve when opening and
closing it.
Figure 77
1. Bypass valve
4. When you are finished pushing or towing the
machine, remove the hydraulic hose that you
installed.
5. Install the existing cap onto the reverse traction
pressure test port.
6. Install the diagnostic-fitting cap onto the fitting
that you installed on the manifold.
7. Rotate the bypass valve 90° (1/4 turn) back
before starting the engine.
2. Hydraulic fluid return filter
77).
Note:
Do not exceed 7 to 11 N∙m (5 to 8 ft-lb)
torque to close the valve.
Pushing or Towing the Machine
Forward Only
If you need to push or tow the machine forward only,
you can just rotate the bypass valve.
Important:
If you need to push or tow the
machine in reverse, refer to
for Pushing or Towing in Reverse (page
1. Open the hood and remove the center shroud.
2. Rotate the bypass valve 90° (1/4 turn) in either
direction to open it and allow fluid to bypass
g033132
internally
Note:
Because the fluid bypasses the
transmission, you can move the machine
forward slowly without damaging the
transmission.
Note the position of the valve when opening and
closing it.
3. Rotate the bypass valve 90° (1/4 turn) back
before starting the engine.
Note:
Do not exceed 7 to 11 N∙m (5 to 8 ft-lb)
torque to close the valve.
g009703
48
Preparing the Machine
(Figure 77).
47).