Toro Reelmaster 7000-D Operator's Manual page 25

Auto Idle
Blade Count
Mow Speed
Height of cut (HOC)
F Reel RPM
R Reel RPM
* Only "operator-faced" text is translated. Faults,
Service, and Diagnostics screens are "service-faced".
Titles will be in the selected language, but menu items
are in English.
Protected under Protected Menus—accessible only
by entering PIN
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 7 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter:
Auto Idle, Time Delay, Blade Count, Mow Speed,
Height of Cut (HOC), F Reel RPM, and R Reel RPM.
These settings can be locked by using the Protected
Menu.
Note:
At the time of delivery, the initial password
code is programmed by your distributor.
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
Controls the amount of time
allowed before returning the
engine to low idle when the
machine is stationary
Controls the number of blades
on the reel for reel speed
Controls the ground speed for
determining the reel speed
Controls the height of cut
(HOC) for determining the reel
speed
Displays the calculated reel
speed position for the front
reels. The reels can also be
manually adjusted
Displays the calculated reel
speed position for the rear
reels. The reels can also be
manually adjusted
Description
Lists the model number of the
machine
Lists the serial number of the
machine
Lists the software revision of
the master controller
Lists the software revision of
the InfoCenter
Lists the machine
communication bus status
If you changed the PIN code and forgot the
code, contact your Authorized Toro Distributor for
assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
2. In the S
ETTINGS
scroll down to the P
the right button
3. To enter the PIN code, press the center button
until the correct first digit appears, then press
the right button to move on to the next digit
(Figure 33B and
until the last digit is entered and press the right
button once more.
4. Press the middle button to enter the PIN code
(Figure 33D).
25
M , use the center button to
ENU
M and press the
ETTINGS ENU
32).
Figure 32
M , use the center button to
ENU
M and press
ROTECTED ENU
(Figure 33A).
Figure 33
Figure 33C). Repeat this step
g028523
g028522