Servicing The Diesel-Oxidation Catalyst (Doc) And The Soot Filter; Fuel System Maintenance; Draining The Fuel Tank; Checking The Fuel Lines And Connections - Toro Reelmaster 7000-D Operator's Manual

5. Apply a light coat of clean oil to the new filter
seal before installing it.
Note:
Do not overtighten the filter.
6. Add oil to the crankcase; refer to
Engine-Oil Level (page
Servicing the
Diesel-Oxidation Catalyst
(DOC) and the Soot Filter
Service Interval: Every 6,000 hours—Disassemble,
clean, and assemble the soot filter
of the DPF or clean the soot filter if
engine faults
3720
display in the InfoCenter.
If engine faults
CHECK ENGINE SPN
3720 0, or
ENGINE SPN FMI
16 display in the InfoCenter(Figure
filter using the steps that follow:
Figure 91
1. Refer to the Engine section in the Service
Manual for information on disassembling and
assembling the diesel-oxidation catalyst and the
soot filter of the DPF.
2. Refer to your authorized Toro distributor for
diesel-oxidation catalyst and the soot filter
replacement parts or service.
3. Contact your authorized Toro distributor to reset
the engine ECU after you install a clean DPF.
Checking the
56).
3251 0,
SPN FMI
0, or 3720
FMI SPN FMI
3251 0,
FMI
3720
CHECK ENGINE SPN
91), clean the soot
Fuel System
Maintenance
DANGER
Under certain conditions, fuel and fuel vapors
are highly flammable and explosive. A fire or
explosion from fuel can burn you and others
and can cause property damage.
• Fill the fuel tank outdoors, in an open area,
when the engine is off and is cold. Wipe up
any fuel that spills.
• Do not fill the fuel tank completely full. Add
fuel to the fuel tank until the level is 25 mm
SPN
(1 inch) below the top of the tank, not the
16
filler neck. This empty space in the tank
allows the fuel to expand.
CHECK
• Never smoke when handling fuel, and stay
FMI
away from an open flame or where fuel
fumes may be ignited by a spark.
• Store fuel in a clean, safety-approved
container and keep the cap in place.

Draining the Fuel Tank

g214715
Service Interval: Every 800 hours
Before storage
Park the machine on a level surface, lower the cutting
units, engage the parking brake, shut off the engine,
g213864 and remove the key.
Drain and clean the fuel tank if the fuel system
becomes contaminated or if the machine is to be
stored for an extended period. Use clean fuel to flush
out the tank.
g213863
Checking the Fuel Lines
and Connections
Service Interval: Every 400 hours/Yearly (whichever
Park the machine on a level surface, lower the cutting
units, engage the parking brake, shut off the engine,
and remove the key.
Inspect the fuel lines for deterioration, damage, or
loose connections.
57
comes first)